Kia Niro: Rear Glass Defogger / Rear Glass Defogger Switch Repair procedures

Kia Niro 2017 (DE HEV) Service Manual / Body Electrical System / Rear Glass Defogger / Rear Glass Defogger Switch Repair procedures

Inspection
1.

In the body electrical system, failure can be quickly diagnosed by using the vehicle diagnostic system (KDS/GDS).

The diagnostic system (KDS/GDS) provides the following information.

(1)

Self diagnosis : Checking failure and code number (DTC)

(2)

Current data : Checking the system input/output data state

(3)

Actuation test : Checking the system operation condition

(4)

Additional function : Controlling other features including system option setting and zero point adjustment

2.

Select the 'Car model' and the 'Body Control Module (BCM)' to be checked in order to check the vehicle with the tester.

3.

Select the 'Current Data' menu to search the current state of the input/output data.

4.

To forcibly actuate the input value of the module to be checked, select option 'Actuation Test'

Removal
1.

Disconnect the negative (-) battery terminal.

2.

Remove the heater and A/C controll unit.

(Refer to Heating, Ventilation, Air conditioning - "Heater & A/C Control Unit (Dual)")

Installation
1.

Install the heater and A/C control unit.

2.

Connect the negative (-) battery terminal.

Rear Glass Defogger Printed Heater Repair procedures
Inspection    • Wrap tin foil around the end of the voltmeter test lead to prevent damagi ...

Rear Wiper/Washer
...

Other information:

Kia Niro (DE HEV) Owners Manual: Charging System Warning Light
This warning light illuminates: Once you set the ignition switch or Engine Start/Stop Button to the ON position. - It remains on until the engine is started. When there is a malfunction with either the alternator or electrical charging system. If there is a malfunction with either th ...

Kia Niro 2017 (DE HEV) Service Manual: A/C Pressure Transducer Repair procedures
Inspection 1. Measure the pressure of high pressure line by measuring voltage output between terminals "1" and “2”. 2. Check if the voltage is within specification. Voltage = 0.00878835 * Pressure + ...

© 2016-2019 www.kniro.net