Kia Niro: Rear Door / Rear Door Trim Repair procedures

Replacement
  

Put on gloves to protect your hands.

  

Use a plastic panel removal tool to remove interior trim pieces without marring the surface.

Be careful not to bend or scratch the trim and panels.

1.

Remove the rear door delta inner cover (A) using a remover.

2.

Remove the rear door inside cap (A) and then loosen the screws.

3.

Remove the rear door pull cap (A) and then loosen the screws.

4.

Remove the rear door trim (A).

5.

Remove the rear door inside handle cage (A).

6.

Disconnect the power window switch connector (A).

7.

Install in the reverse order of removal.

  

Make sure the connector is connected properly.

Make sure the door locks/unlocks and opens/closes properly.

Replace any damaged clips.

Rear Door Trim Components and components location
Component Location 1. Rear door trim ...

Rear Door Inside Handle Repair procedures
Replacement    Put on gloves to protect your hands.    ...

Other information:

Kia Niro 2017 (DE HEV) Service Manual: Rail Pressure Sensor (RPS) Description and operation
Description Installed on the delivery pipe, the Rail Pressure Sensor (RPS) measures the instantaneous fuel pressure in the delivery pipe. The sensing element (Semiconductor element) built in the sensor converts the pressure to voltage signal. By using this signal, the ECM can cont ...

Kia Niro (DE HEV) Owners Manual: To increase cruise control set speed
Follow either of these procedures: Move the lever up (to RES+), and hold it. Your vehicle set speed will increase by 10 km/h (5 mph). Release the lever at the speed you want. Move the lever up (to RES+), and release it immediately.The cruising speed will increase by 1.0 km/h (1.0 mph) ...

© 2016-2019 www.kniro.net