Kia Niro: Rear Door / Rear Door Outside Handle Repair procedures

Kia Niro 2017 (DE HEV) Service Manual / Body (Interior and Exterior) / Rear Door / Rear Door Outside Handle Repair procedures

Replacement
  

Put on gloves to protect your hands.

  

Use a plastic panel removal tool to remove interior trim pieces without marring the surface.

Be careful not to bend or scratch the trim and panels.

1.

Remove the rear door trim.

(Refer to Rear Door - "Rear Door Trim")

2.

Remove the rear door outside handle cover (A) after loosening the mounting bolt.

Tightening torque :

3.9 - 5.9 N·m (0.4 - 0.6 kgf·m, 2.9 - 4.3 lb·ft)

3.

Remove the rear door outside handle (A) by sliding it rearward.

4.

Install in the reverse order of removal.

  

Be sure to install the outside handle pad (A) between the outside handle and the door panel.

Make sure that the connector is connected properly.

Make sure that the door locks/unlocks and opens/closes properly.

Rear Door Outside Handle Components and components location
Component Location 1. Rear door outside handle ...

Rear Door Latch Components and components location
Component Location 1. Rear door latch ...

Other information:

Kia Niro 2017 (DE HEV) Service Manual: DCT(Dual Clutch Transmission) Components and components location
Components 1. Hybrid drive motor assembly 2. DCT (Dual Clutch Transmission) assembly 3. Gear actuator assembly 4. DCT support bracket 5. Inhibitor switch 6. Clutch actuator assembly 7. Dual clutch assembly 8. Engine clutch actuator as ...

Kia Niro 2017 (DE HEV) Service Manual: Accelerator Position Sensor (APS) Repair procedures
Inspection 1. Connect the KDS/GDS on the Data Link Connector (DLC). 2. Switch "ON" the ignition. 3. Measure the output voltage of the APS 1 and 2 at C.T and W.O.T. Accelerator Pos ...

© 2016-2024 www.kniro.net