Kia Niro: Rear Door / Rear Door Latch Repair procedures

Replacement
  

Put on gloves to protect your hands.

  

Use a plastic panel removal tool to remove interior trim pieces without marring the surface.

Be careful not to bend or scratch the trim and panels.

1.

Remove the rear door module.

(Refer to Rear Door - "Rear Door Module")

2.

Loosen the rear door outside handle base mounting bolt (A).

3.

Remove the rear door latch (B) after loosening the mounting screw (A).

4.

Install in the reverse order of removal.

  

Make sure that the connector is connected properly.

Make sure that the door locks/unlocks and opens/closes properly.

Replace any damaged clips.

Rear Door Latch Components and components location
Component Location 1. Rear door latch ...

Rear Door Belt Outside Weatherstrip Repair procedures
Replacement 1. Pull down the rear door window glass to the lowest level by pressing the power window glass switch. 2. Remove the rear door bel ...

Other information:

Kia Niro 2017 (DE HEV) Service Manual: Rear Oil Seal Repair procedures
Replacement    • Be sure to read and follow the “General Safety Information and Caution” before doing any work related with the high voltage system. Failure to follow the safety i ...

Kia Niro 2017 (DE HEV) Service Manual: Blind Spot Detection Switch Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad Lower Panel") 3. Remove the crash pad plate [LH] (A) after loosening the screws. ...

© 2016-2024 www.kniro.net