Kia Niro: Windows / Power windows

The ignition switch must be in the ON position for power windows to operate.

Each door has a power window switch that controls the door's window. The driver has a power window lock button which can block the operation of passenger windows. The power windows can be operated for approximately 30 seconds after the ignition key is removed or turned to the ACC or LOCK position. However, if the front doors are opened, the power windows cannot be operated even within the 30 second period.

The driver’s door has a master power window switch that controls all the windows in the vehicle.

If the window cannot be close because it is blocked by objects, remove the objects and close the window.

✽ NOTICE

While driving with the rear windows down or with the sunroof (if equipped) in an open (or partially open position), your vehicle may demonstrate a wind buffeting or pulsation noise. This noise is a normal occurrence and can be reduced or eliminated by taking the following actions. If the noise occurs with one or both of the rear windows down, partially lower both front windows approximately one inch. If you experience the noise with the sunroof open, slightly reduce the size of the sunroof opening.

WARNING

Do not install any accessories in the area of windows. It may impact jam protection.

Windows
(1) Driver’s door power window switch (2) Front passenger’s door power window switch (3) Rear door (left) power window switch (4) Rear door (right) power window switch (5) Window opening and ...

Window opening and closing
Type A To open or close a window, press down or pull up the front portion of the corresponding switch to the first detent position (5). Type B - Auto up/down window Pressing or pulling up the ...

Other information:

Kia Niro 2017 (DE HEV) Service Manual: Center Pillar Trim Repair procedures
Replacement [Center pillar lower trim]    Put on gloves to protect your hands.    • Use a plastic panel removal to ...

Kia Niro 2017 (DE HEV) Service Manual: Troubleshooting
Failure Diagnosis 1. In principle, ESP and TCS controls are prohibited in case of ABS failure. 2. When ESP or TCS fails, only the failed system control is prohibited. 3. However, when the solenoid valve relay shoul ...

© 2016-2019 www.kniro.net