Inspection |
[Non-IMS Type] |
1. |
Check for continuity between the terminals. If there is an abnormality, replace the switch.
|
[IMS Type] |
Diagnosis With KDS/GDS
1. |
The body electrical system can be quickly diagnosed for failed parts by using vehicle diagnostic system (KDS/GDS). The diagnostic system (KDS/GDS) provides the following information.
|
2. |
Select the 'Car model' and the system to be checked in order to check the vehicle with the tester. |
3. |
Select the 'Body Control Module (BCM)' to check the driver seat or assist door module (DDM/ADM). |
4. |
Select the "Current Data" menu to check the current state of the input/output data. The input/output data for the sensors corresponding to the driver seat or assist door module (DDM/ADM) can be checked.
|
5. |
To check the power door lock operation by force, select "Actuation test". |
Removal |
|
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the front door trim. (Refer to Body - "Front Door Trim") |
3. |
Remove the power window switch assembly (A) after loosening the mounting screws.
|
Installation |
1. |
Install the power window switch assembly. |
2. |
Install the front door trim after connecting the connector. |
3. |
Connect the negative (-) battery terminal. |
Kia Niro 2017 (DE HEV) Service Manual: Hybrid Power Control Unit (HPCU) Components and components location
Components
1. Hybrid Control Unit(HCU) [HPCU]
2. Inverter [HPCU]
3. Low Voltage DC/DC Converter (LDC) [HPCU]
4. High voltage connector (↔ High voltage battery system assembly)
5. High voltage connector (↔ Hybrid drive motor assembly)
6. H ...
Kia Niro (DE HEV) Owners Manual: Wheel alignment and tire balance
The wheels on your vehicle were aligned and balanced carefully at the factory
to give you the longest tire life and best overall performance.
In most cases, you will not need to have your wheels aligned again. However,
if you notice unusual tire wear or your vehicle pulling one way or the other ...