Kia Niro: Turn signals and lane change signals / One-touch lane change function
To activate an one-touch lane change function, move the turn signal lever slightly for less than 0.7 second and then release it. The lane change signals will blink 3 times.
✽ NOTICE
If an indicator flash is abnormally quick or slow, a bulb may be burned out or have a poor electrical connection in the circuit.
Turn signals and lane change signals
The ignition switch must be on for the turn signals to function. To turn on the
turn signals, move the lever up or down (A). The green arrow indicators on the instrument
panel indicate which tur ...
Front fog light
Fog lights are used to provide improved visibility when visibility is poor due
to fog, rain or snow, etc. The fog lights will turn on when the fog light switch
(1) is turned on after the parklig ...
Other information:
Kia Niro 2017 (DE HEV) Service Manual: Crankshaft Position Sensor (CKPS) Troubleshooting
Signal Waveform
This example shows a typical Crankshaft Position Sensor (CKPS) and Camshaft Position
Sensor (CMPS) waveforms at idle. The PCM controls the injection and ignition timing
by using these signals.
Generally, the CKPS signal is used to detect the piston position whe ...
Kia Niro 2017 (DE HEV) Service Manual: Rear Oil Seal Repair procedures
Replacement
•
Be sure to read and follow the “General Safety Information and
Caution” before doing any work related with the high voltage system.
Failure to follow the safety i ...