Kia Niro: Scheduled maintenance service / Maintenance Under Severe Usage Conditions - For Gasoline Engine

Kia Niro (DE HEV) Owners Manual / Maintenance / Scheduled maintenance service / Maintenance Under Severe Usage Conditions - For Gasoline Engine

Maintenance operation

I : Inspect and if necessary, adjust, correct, clean or replace.

R : Replace or change.

SEVERE DRIVING CONDITIONS

A : Repeatedly driving short distance of less than 8 km (5miles) in normal temperature or less than 16 km (10 miles) in freezing temperature.
B : Extensive engine idling or low speed driving for long distances.
C : Driving on rough, dusty, muddy, unpaved, graveled or saltspread roads.
D : Driving in areas using salt or other corrosive materials or in very cold weather
E : Driving in heavy dust condition
F : Driving in heavy traffic area
G : Driving on uphill, downhill, or mountain roads.
H : Towing a trailer or using a camper on roof rack.
I : Driving for patrol car, taxi, commercial car or vehicle towing.
J : Driving in very cold weather.
K : Driving over 170 km/h (106 mile/h).
L : Frequently driving in stop-and-go conditions.

Normal Maintenance Schedule - For Gasoline Engine
The following maintenance services must be performed to ensure good emission control and performance. Keep receipts for all vehicle emission services to protect your warranty.Where both mileage an ...

Explanation of scheduled maintenance items
Engine oil and filter The engine oil and filter should be changed at the intervals specified in the maintenance schedule. If the vehicle is being driven in severe conditions, more frequent oil an ...

Other information:

Kia Niro (DE HEV) Owners Manual: On curves
On curves, the smart cruise control system may not detect a moving vehicle in your lane, and then your vehicle could accelerate to the set speed. Also, the vehicle speed will rapidly down when the vehicle ahead is recognized suddenly. Select the appropriate set speed on curves and adjust ...

Kia Niro 2017 (DE HEV) Service Manual: Rail Pressure Sensor (RPS) Repair procedures
Inspection 1. Connect the KDS/GDS on the Data Link Connector (DLC). 2. Measure the output voltage of the RPS during idle at various engine speeds. Pressure Output Voltage (V) [Vref=5V] ...

© 2016-2018 www.kniro.net