Kia Niro: Seat belt restraint system / Lap belt

To fasten your seat belt:

To fasten a 2-point static type belt, insert the metal tab (1) into the locking buckle (2). There will be an audible "click" when the tab locks into the buckle. Check to make sure the belt is properly locked and that the belt is not twisted.

With a 2-point static type seat belt, the length must be adjusted manually so it fits snugly around your body. Fasten the belt and pull on the loose end to tighten. The belt should be placed as low as possible on your hips (1), not on your waist. If the belt is too high, it could increase the possibility of your being injured in an accident.

When using the rear center seat belt, the buckle with the “CENTER” mark must be used.

To release the seat belt:

When you want to release the seat belt, press the button (1) in the locking buckle.

WARNING

The center lap belt latching mechanism is different from those for the rear seat shoulder belts. When fastening the rear seat shoulder belts or the center lap belt, make sure they are inserted into the correct buckles to obtain maximum protection from the seat belt system and assure proper operation.

Lap/Shoulder belt
Height adjustment (For Front seat) You can adjust the height of the shoulder belt anchor to one of 4 positions for maximum comfort and safety. The height of the adjusting seat belt should not be ...

Stowing the rear seat belt
■ Outboard belt ■ Center belt If the center seat belt is not in use, always lock the latch plate into the buckle as above illustration. The rear seat belt buckles can be stowed in th ...

Other information:

Kia Niro (DE HEV) Owners Manual: Driving in the rain
Rain and wet roads can make driving dangerous, especially if you’re not prepared for the slick pavement. Here are a few things to consider when driving in the rain: A heavy rainfall will make it harder to see and will increase the distance needed to stop your vehicle, so slow down. Keep ...

Kia Niro 2017 (DE HEV) Service Manual: Blind Spot Detection Radar Calibration Description and operation
Description To correctly sense vehicles on the neighboring lanes using the radar, the direction of the sensor and the direction of the vehicle must be aligned. This is the BSD unit alignment. If this alignment is not performed as in illustration below, it may cause degradation of ...

© 2016-2018 www.kniro.net