Kia Niro: Engine Control System / Knock Sensor (KS) Schematic diagrams

Circuit Diagram

Harness Connector

Knock Sensor (KS) Description and operation
Description Knocking is a phenomenon characterized by undesirable vibration and noise that can cause engine damage. Knock Sensor (KS) is installed on the cylinder block and senses eng ...

Knock Sensor (KS) Repair procedures
Removal 1. Switch "OFF" the ignition and disconnect the negative (-) battery terminal. 2. Remove the intake manifold. (Refer to Engi ...

Other information:

Kia Niro (DE HEV) Owners Manual: Checking the tire inflation pressure
1. After driving approximately 7~10 km (4~6 miles or about 10 minutes), stop at a suitable location. 2. • Connect connection hose (10) of the compressor directly to the tire valve. (18 inch tire only) • Connect the filling hose (3) of the compressor (clip mounted side) directly and then ...

Kia Niro (DE HEV) Owners Manual: Tailgate room lamp bulb replacement
1. Using a flat-blade screwdriver, gently pry the lens cover from lamp housing. 2. Remove the bulb by pulling it straight out. 3. Install a new bulb in the socket. 4. Align the lens cover tabs with the lamp housing notches and snap the lens into place. CAUTION Be careful not to dirty or dam ...

© 2016-2020 www.kniro.net