Kia Niro: Dual Clutch Transmission Control System / Input Speed Sensor Specification

Specification
Item
Specification
Type
Hall effect sensor
Operating condition
-22 to 257 ° F (-30 to 125 ° C)
Output signal
High: 11.8 - 16.8 mA
Low: 5.9 - 8.4 mA

Input Speed Sensor Components and components location
Component Location 1. Input speed sensor ...

Input Speed Sensor Description and operation
Description • The input shaft speed sensor is important in that it detects the input shaft RPM and sends this information to the Transmission Control Module (TCM) ...

Other information:

Kia Niro 2017 (DE HEV) Service Manual: Seat Heater Switch Repair procedures
Removal [Front Seat] 1. Disconnect the negative (-) battery terminal. 2. Remove the floor console assembly. (Refer to Body - "Floor Console Assembly") 3. Disconnect the front seat heater switch connector ( ...

Kia Niro (DE HEV) Owners Manual: In case of an emergency while driving
If the engine stalls at a crossroad or crossing • If the engine stalls at a crossroad or crossing, set the shift lever in the N (Neutral) position and then push the vehicle to a safe place. If you have a flat tire while driving If a tire goes flat while you are driving: 1. Take your foot off ...

© 2016-2019 www.kniro.net