Kia Niro: Dual Clutch Transmission Control System / Inhibitor Switch Description and operation

Description

The inhibitor switch is installed on top of transmission, and is connected to the shift lever through shift cable.

Inhibitor switch signals (S1, S2, S3, S4) are transmitted to the TCM according to the driver's shift lever control.

Inhibitor Switch Specification
Specification Item Specification Power supply 12 V Output type Combination of output signals ...

Inhibitor Switch Schematic diagrams
Schematic Diagrams ...

Other information:

Kia Niro 2017 (DE HEV) Service Manual: Repair procedures
Compression Pressure Inspection    If the there is lack of power, excessive oil consumption or poor fuel economy, measure the compression pressure. 1. Warm up and stop the engine. Allow ...

Kia Niro 2017 (DE HEV) Service Manual: Power Relay Assembly (PRA) Description and operation
Description The Power Relay Assembly (PRA) consists of the positive and negative main relays, pre-charge relay, pre-charge resistor and battery current sensor. It is located inside the battery pack assembly and controls the high voltage power circuit between the high voltage batte ...

© 2016-2018 www.kniro.net