Kia Niro: What to do in an emergency / If the engine overheats

If your temperature gauge indicates overheating, you will experience a loss of power, or hear loud pinging or knocking, the engine is probably too hot. If this happens, you should:

1.Pull off the road and stop as soon as it is safe to do so.

2.Place the shift lever in P (dual clutch transmission) and set the parking brake. If the air conditioning is on, turn it off.

3.If engine coolant is running out under the vehicle or steam is coming out from the hood, stop the engine. Do not open the hood until the coolant has stopped running or the steaming has stopped. If there is no visible loss of engine coolant and no steam, leave the engine running and check to be sure the engine cooling fan is operating. If the fan is not running, turn the engine off.

4.Check to see if the water pump drive belt is missing. If it is not missing, check to see that it is tight.

If the drive belt seems to be satisfactory, check for coolant leaking from the radiator, hoses or under the vehicle. (If the air conditioning had been in use, it is normal for cold water to be draining from it when you stop).

WARNING

While the engine is running, keep hair, hands and clothing away from moving parts such as the fan and drive belts to prevent injury.

5.If the water pump drive belt is broken or engine coolant is leaking out, stop the engine immediately and we recommend that you call an authorized Kia dealer.

WARNING

Do not remove the radiator cap when the engine is hot.This can allow coolant to blow out of the opening and cause serious burns.

6.If you cannot find the cause of the overheating, wait until the engine temperature has returned to normal. Then, if coolant has been lost, carefully add coolant to the reservoir to bring the fluid level in the reservoir up to the halfway mark.

7.Proceed with caution, keeping alert for further signs of overheating. If overheating happens again, we recommend that you call an authorized Kia dealer.

CAUTION

Push-starting
Vehicles equipped with dual clutch transmission cannot be push-started. Follow the directions in this section for jump-starting. WARNING Never tow a vehicle to start it because the sudden surge fo ...

Tire Pressure Monitoring System (TPMS)
(1) Low tire pressure telltale / TPMS malfunction indicator (2) Low tire pressure position telltale (Shown on the LCD display) ...

Other information:

Kia Niro 2017 (DE HEV) Service Manual: Description and operation
Description BSD is a system that uses two magnetic wave radar sensors attached on the rear panel to measure the distance from the vehicle in the back and senses and sets off (visual and auditory) alarms for any vehicle coming into the blind spot. – Blind Spot ...

Kia Niro (DE HEV) Owners Manual: Auto light
When the light switch is in the AUTO light position, the taillights and headlights will be turned ON or OFF automatically depending on the amount of light outside the vehicle. CAUTION Never place anything over the sensor (1) located on the instrument panel. This will ensure better auto ...

© 2016-2019 www.kniro.net