Kia Niro: Lighting / High beam operation
To turn on the high beam headlamp, push the lever away from you. The lever will return to its original position.
The high beam indicator will light when the headlight high beams are switched on.
To turn off the high beam headlamp, pull the lever to you when the high beam is on. The lever will return to its original position.
To prevent the battery from being discharged, do not leave the lights on for a prolonged time while the engine is not running.
WARNING
Do not use high beam when there are other vehicles. Using high beam could obstruct the other driver’s vision.
To flash the headlights, pull the lever towards you. It will return to the normal (low beam) position when released. The headlight switch does not need to be on to use this flashing feature.
Auto light
When the light switch is in the AUTO light position, the taillights and headlights
will be turned ON or OFF automatically depending on the amount of light outside
the vehicle.
CAUTION
Never ...
Turn signals and lane change signals
The ignition switch must be on for the turn signals to function. To turn on the
turn signals, move the lever up or down (A). The green arrow indicators on the instrument
panel indicate which tur ...
Other information:
Kia Niro (DE HEV) Owners Manual: Blade inspection
✽ NOTICE
Commercial hot waxes applied by automatic car washes have been known to make
the windshield difficult to clean.
Contamination of either the windshield or the wiper blades with foreign matter
can reduce the effectiveness of the windshield wipers. Common sources of contamination
a ...
Kia Niro 2017 (DE HEV) Service Manual: Repair procedures
General Inspection
Before and after servicing the EPS system, perform the troubleshooting and
test procedure as follows.
Compare the system condition with normal condition in the table below and
if abnormal symptom is detected, perform necessary remedy and inspe ...