Kia Niro: Light bulbs / Headlamp (High/Low beam) bulb replacement
1. Open the hood.
2. Remove the headlamp bulb cover by turning it counterclockwise.
3. Disconnect the headlamp bulb socket-connector.
4. Remove the bulb-socket from the headlamp assembly by turning the bulb-socket counterclockwise until the tabs on the bulb-socket align with the slots on the headlamp assembly.
5. Install a new bulb-socket assembly in the headlamp assembly by aligning the tabs on the bulb-socket with the slots in the headlamp assembly. Push the bulb-socket into the headlamp assembly and turn the bulb-socket clockwise.
6. Install the headlamp bulb cover by turning it clockwise.
Headlamp (HID type) bulb replacement
If the light bulb does not operate, we recommend that you checked an authorized
Kia dealer.
WARNING - HID Headlamp (if equipped)
Do not attempt to replace or inspect the HID headlamp (XENON bulb) ...
Headlamp bulb
WARNING - Halogen bulbs
Halogen bulbs contain pressurized gas that will produce flying pieces
of glass if broken.
Always handle them carefully, and avoid scratches and abrasions. If the
...
Other information:
Kia Niro 2017 (DE HEV) Service Manual: Disc Brakes and Pads Repair procedures
Inspection
Check the pads for excessive wear, discs for run out and wear, and calipers for
fluid leakage.
Front Brake
Front brake disc thickness
check
1.
Check the brake pads for wear and fade.
2.
Check the brake disc for dama ...
Kia Niro 2017 (DE HEV) Service Manual: Blind Spot Detection Radar Calibration Description and operation
Description
To correctly sense vehicles on the neighboring lanes using the radar, the direction
of the sensor and the direction of the vehicle must be aligned.
This is the BSD unit alignment. If this alignment is not performed as in illustration
below, it may cause degradation of ...