Kia Niro: Headlamp and front fog lamp aiming / Head lamp low beam (LHD)

1. Turn the low beam on without driver aboard.

2. The cut-off line should be projected in the cut-off line shown in the picture.

3. When aiming the low beam, vertical aiming should be adjusted after adjusting the horizontal aiming.

4. If head lamp leveling device is equipped, adjust the head lamp leveling device switch with 0 positions.

A : Vertical line of the left head lamp (low) bulb center
B : Vertical line of the right head lamp (low) bulb center
C : Horizontal line of head lamp (low) bulb center
D : Cut – Off line
E : Car Axis
F : Ground

Aiming point
A : Vertical line of the left head lamp (low) bulb center B : Vertical line of the right head lamp (low) bulb center C : Horizontal line of head lamp (low) bulb center D : Cut – Off line E ...

Head lamp low beam (RHD)
1. Turn the low beam on without driver aboard. 2. The cut-off line should be projected in the cut-off line shown in the picture. 3. When aiming the low beam, vertical aiming should be adjusted after ...

Other information:

Kia Niro 2017 (DE HEV) Service Manual: Photo Sensor Description and operation
Description The photo sensor is located at the center of the defrost nozzles. The photo sensor contains a photovoltaic (sensitive to sunlight) diode. The solar radiation received by its light receiving portion, generates an electromotive force in proportion to the amount of radia ...

Kia Niro 2017 (DE HEV) Service Manual: Clutch Engagement Fork and Engagement Bearing Repair procedures
Removal 1. Remove the dual clutch assembly. (Refer to Dual Clutch System - "Dual Clutch Assembly") 2. Remove the clutch engagement bearing 1 (A) and 2 (B). 3. Remove the clutch engagement fork 1 (A) ...

© 2016-2020 www.kniro.net