Kia Niro: Fuel Delivery System / Fuel Pump Control Module (FPCM) Schematic diagrams

Kia Niro 2017 (DE HEV) Service Manual / Engine Control/Fuel System / Fuel Delivery System / Fuel Pump Control Module (FPCM) Schematic diagrams

Circuit Diagram

Terminal Information
Terminal Illustration

Terminal Function
Pin No.
Description
1
Fuel Sender (-)
2
Fuel pressure sensor (FPS) signal input
3
Fuel pressure sensor (FPS) ground
4
Ground (-)
5
CAN [Low]
6
Fuel Sender (+)
7
-
8
Fuel Pressure Sensor (FPS) Power [+5V]
9
CAN [High]
10
Battery Power (B+)

Fuel Pump Control Module (FPCM) Description and operation
Description Installed on the right hand side of the fuel tank, the Fuel Pump Control Module (FPCM) controls the DC motor mounted inside the low pressure fuel pump. The module compares ...

Fuel Pump Control Module (FPCM) Repair procedures
Removal 1. Switch "OFF" the ignition and disconnect the negative (-) battery terminal. 2. Remove the rear seat cushion. (Refer t ...

Other information:

Kia Niro 2017 (DE HEV) Service Manual: Hybrid Control Unit (HCU) Repair procedures
Removal    • Be sure to read and follow the “General Safety Information and Caution” before doing any work related with the high voltage system. Failure to follow the safety instr ...

Kia Niro 2017 (DE HEV) Service Manual: Inspection mode procedures
Procedure for entering engine forced activation mode If the engine needs to be running constantly while the vehicle is stopped to inspect emission gas or perform maintenance on the vehicle, follow below procedure to enter engine forced activation mode. 1. Place ...

© 2016-2019 www.kniro.net