Kia Niro: Front Seat / Front Seat Cushion Cover Repair procedures

Kia Niro 2017 (DE HEV) Service Manual / Body (Interior and Exterior) / Front Seat / Front Seat Cushion Cover Repair procedures

Replacement
  

Put on gloves to protect your hands.

  

Use a plastic panel removal tool to remove interior trim pieces without marring the surface.

Be careful not to bend or scratch the trim and panels.

1.

Remove the front seat shield inner cover.

(Refer to Front Seat - "Front Seat Shield Inner Cover")

2.

Remove the front seat outer shield cover.

(Refer to Front Seat - "Front Seat Outer Shield Cover")

3.

Remove the front seat lower protector (A).

4.

Disconnect the airbag connector (A), heater connector (B), and extension wiring connector (C).

5.

Pull out the protectors (A), and then separate the front seat cushion cover from the front seat cushion frame.

6.

Remove the front seat cushion cover (A) from the front seat cushion frame.

7.

Remove the velcro tape (A) and hog-ring clips (B) from the front of seat cushion.

8.

Install in the reverse order of removal.

  

Make sure that the connectors are plugged in properly.

Replace any damaged clips.

To prevent wrinkles, make sure that the material is stretched evenly over the cover (B) before securing the hog-ring clips (A).

Replace the hog-ring clips with new ones using special tool (C) (09880-4F000).

Front Seat Cushion Cover Components and components location
Component Location 1. Front seat cushion cover ...

Front Seat Frame Assembly Components and components location
Component Location 1. Front seat back frame assembly 2. Front seat cushion frame assembly ...

Other information:

Kia Niro 2017 (DE HEV) Service Manual: Rear Bumper Cover Repair procedures
Replacement    Put on gloves to protect your hands.    • Use a plastic panel removal tool to remove interior trim pie ...

Kia Niro 2017 (DE HEV) Service Manual: Idler Repair procedures
Removal and Installation 1. Remove the drive belt. (Refer to Drive Belt System - "Drive Belt") 2. Remove the idler (A). Tightening torque : 39.2 - 49.0 N·m (4.0 - 5.0 kgf·m, 28.9 - 36.2 lb·ft) ...

© 2016-2024 www.kniro.net