Kia Niro: Timing System / Front Oil Seal Repair procedures

Replacement
1.

Remove the crankshaft damper pulley.

(Refer to Drive Belt System - "Crankshaft Damper Pulley")

2.

Remove the front oil seal (A).

3.

Apply engine oil to a new oil seal lip & outer surface.

  

Remove any debris from the lip portion of the oil seal.

4.

Using the SSTs (09231-G2100, 09231-H1100), install the front oil seal (A).

  

Always use new oil seal.

5.

Install the crankshaft damper pulley.

(Refer to Drive Belt System - "Crankshaft Damper Pulley")

Components and components location
Components 1. Front oil seal 2. Timing chain cover 3. Variable force solenoid (VFS) valve 4. O-ring 5. Timing chain tensioner 6. Timing chain ...

Timing Chain Cover Repair procedures
Removal    • Be sure to read and follow the “General Safety Information and Caution” ...

Other information:

Kia Niro 2017 (DE HEV) Service Manual: Repair procedures
General Inspection Before and after servicing the EPS system, perform the troubleshooting and test procedure as follows. Compare the system condition with normal condition in the table below and if abnormal symptom is detected, perform necessary remedy and inspe ...

Kia Niro 2017 (DE HEV) Service Manual: Hybrid Control Unit (HCU) Schematic diagrams
HCU Terminal And Input/Output Signal Terminal Function Connector [C133-S] Pin No. Description Connected to 1 HCU ground Chassis ground 2 HCU ground ...

© 2016-2019 www.kniro.net