Kia Niro: Front Door / Front Door Latch Repair procedures

Replacement
  

Put on gloves to protect your hands.

  

Use a plastic panel removal tool to remove interior trim pieces without marring the surface.

Be careful not to bend or scratch the trim and panels.

1.

Remove the front door module.

(Refer to Front Door - "Front Door Module")

2.

Disconnect the front door latch rod (A) and extension wiring clip (B).

3.

Remove the front door latch (B) after loosening the mounting screw (A).

4.

Install in the reverse order of removal.

  

Make sure the connector is connected properly.

Make sure the door locks/unlocks and opens/closes properly.

Replace any damaged clips.

Front Door Latch Components and components location
Component Location 1. Front door latch ...

Front Door Belt Inside Weatherstrip Repair procedures
Replacement 1. Remove the front door trim. (Refer to Front Door - "Front Door Trim") 2. Remove the front door belt inside weatherstr ...

Other information:

Kia Niro (DE HEV) Owners Manual: Blind spot detection system
The Blind spot detection system uses a radar sensor to alert the driver while driving. It senses the rear side territory of the vehicle and provides information to the driver. ➀ Blind spot detection Warning range is dependent on your vehicle speed. However, if the speed of your vehicle ...

Kia Niro 2017 (DE HEV) Service Manual: Tailgate Assembly Repair procedures
Replacement    Wear gloves to protect hands from injury.    Work in a group of two when removing and installing the tailgate. ...

© 2016-2018 www.kniro.net