Peugeot 2008: Practical information / Free-wheeling

In certain situations, you must allow the vehicle to free-wheel (while being towed, on a rolling road, in an automatic car wash, or being transported by rail or sea freight, etc.).

The procedure varies according to the type of gearbox and parking brake.

With manual or EAT6 automatic gearbox and electric parking brake

Peugeot 2008. Free-wheeling

Release procedure

Reverting to normal operation

With EAT8 automatic gearbox and manual parking brake

Peugeot 2008. Free-wheeling

Release procedure

Within 5  seconds:

Reverting to normal operation

With EAT8 automatic gearbox or drive selector and electric parking brake

Peugeot 2008. Free-wheeling

Release procedure

Within 5  seconds:

If the 5-second time limit is exceeded, the gearbox engages mode P; it is then necessary to restart the procedure.

Reverting to normal operation

Peugeot 2008. Free-wheeling Keyless Entry and Starting

You must not depress the brake pedal while switching the ignition on or off. If you do, the engine will start, requiring you to restart the procedure.

AdBlue® (BlueHDi)
To respect the environment and ensure compliance with the Euro 6 standard, without adversely affecting the performance or fuel consumption of its Diesel engines, PEUGEOT has taken the decision to e ...

Advice on care and maintenance
General recommendations Observe the following recommendations to avoid damaging the vehicle. Exterior Never use a high-pressure jet wash in the engine compartment - risk of damaging the electrical ...

Other information:

Kia Niro 2017 (DE HEV) Service Manual: Components and components location
Components Location 1. Hybrid Power Control Unit (HPCU) 2. Hybrid Control Unit (HCU) 3. Brake Switch 4. DC Fuse    HPCU includes the HCU (Hybrid Control Unit), Inverters ...

Kia Niro 2017 (DE HEV) Service Manual: Variable Force Solenoid (VFS) Repair procedures
Removal 1. Switch "OFF" the ignition and disconnect the negative (-) battery terminal. 2. Disconnect the VFS connector (A). 3. Remove the mounting bolts (B), and then remove the VFS from the engine. ...

© 2016-2021 www.kniro.net