Kia Niro: Fuel Delivery System / Filler-Neck Assembly Repair procedures

Removal
1.

Open the fuel filler door.

2.

Switch "OFF" the ignition and disconnect the negative (-) terminal of the auxiliary 12V battery.

3.

Remove the filler-neck assembly mounting bolt (A).

4.

Lift the vehicle.

5.

Remove the rear-LH wheel, tire, and the inner wheel house (A).

6.

Disconenct the fuel filler hose (A) and leveling hose (B).

7.

Disconnect the ventilation tube quick-connector (C).

8.

Remove the filler-neck assembly (B) after loosening the mounting bolt (A).

Installation
1.

Install in the reverse order of removal.

Fuel Line Repair procedures
Removal Low Pressure Fuel Line [High Pressure Fuel Pump ↔ Fuel Tank] 1. Release the residual pressure in fuel line. (Refer to the Fuel Delivery System - "Rele ...

Fuel Pump Control Module (FPCM) Description and operation
Description Installed on the right hand side of the fuel tank, the Fuel Pump Control Module (FPCM) controls the DC motor mounted inside the low pressure fuel pump. The module compares ...

Other information:

Kia Niro 2017 (DE HEV) Service Manual: Description and operation
Description If the Gasoline Engine Control system components (sensors, ECM, injector, etc.) fail, interruption to the fuel supply or failure to supply the proper amount of fuel for various engine operating conditions will result. The following situations may be encountered. ...

Kia Niro 2017 (DE HEV) Service Manual: Air Cleaner Repair procedures
Removal and Installation Air Cleaner Assembly 1. Disconnect the air duct B (A). Tightening torque : 2.9 - 4.9 N·m (0.3 - 0.5 kgf·m, 2.2 - 3.6 lb·ft) 2. Disconnect the mass air flow sensor (MAFS) c ...

© 2016-2019 www.kniro.net