Kia Niro: Hybrid Control System / Description and operation

Hybrid Electric Vehicle (HEV)
Hybrid Electric Vehicle (HEV) uses a hybrid power source in the form of combination of combustion engine and electric motor. This will increase the fuel efficiency and emit less harmful exhaust emissions over conventional vehicles with combustion engine system.
In Electric Vehicle (EV) mode, the HEV is driven by only the electric motor, but engine supports the motor in case the vehicle needs more power (HEV Mode).
The electric motor not only drives the vehicle but also generates electric energy during regenerative braking for charging the high voltage battery.


[HEV Operation Mode and Power Flow]

[Warning Lamp]

Items
Description
Related Control Module
1. MIL Lamp

Lamp ON : Engine Management System (EMS) fault


2. Service Lamp

Lamp ON : Hybrid related system fault


3. READY Lamp

After ignition START

Lamp ON : HEV in normal condition is ready to drive (Engine may or may not start)

Lamp OFF : HEV is not ready to drive

During driving

Lamp ON : HEV is ready to drive

Lamp Blinking : HEV in faulty condition (HEV in limited operating mode)

Lamp OFF : HEV is not ready to drive

HPCU (HCU)
4. EV MODE Lamp

Lamp ON : EV mode (Electric motor only)

Lamp OFF : HEV mode (Engine running)

HPCU (HCU)

Special service tools
Special Service Tools Tool Name / Number Illustration Description Insulated Tool Set 0K375-4U000 Use ...

Components and components location
Component Location 1. Engine 2. Hybrid Drive Motor Assembly 3. Hybrid Starter Generator (HSG) 4. Transaxle 5. High Voltage Battery System Assembly ...

Other information:

Kia Niro (DE HEV) Owners Manual: User Settings Mode
On this mode, you can change setting of the doors, lamps, and so on. WARNING Do not adjust the User Setting while driving.You may lose your steering control and cause severe personal injury or accidents. Driving Assist Lane Keeping Assist System (LKAS, if equipped) : To adjust the sensi ...

Kia Niro 2017 (DE HEV) Service Manual: Filler-Neck Assembly Repair procedures
Removal 1. Open the fuel filler door. 2. Switch "OFF" the ignition and disconnect the negative (-) terminal of the auxiliary 12V battery. 3. Remove the filler-neck assembly mounting bolt (A). ...

© 2016-2019 www.kniro.net