Kia Niro: Hybrid Motor Assembly / Description and operation

Description

The hybrid motor system is equipped with two electric motors - HSG and drive motor.

The traction motor operates to move the vehicle, to reduce Noise, Vibration, and Harshness (NVH) while driving and to improve fuel efficiency.

The electric motor takes on the role of a generator during deceleration and braking.

The Hybrid Starter Generator (HSG) starts the engine while the vehicle is in motion.

Hybrid Motor Assembly
...

Hybrid Drive Motor Assembly Components and components location
Components 1. Dual clutch transmission (DCT) assembly 2. Hybrid drive motor assembly 3. Concentric slave cylinder 4. Engine clutch actuator assembly ...

Other information:

Kia Niro (DE HEV) Owners Manual: Stop and tail lamp bulb replacement
1. Open the tailgate. 2. Open the service cover. 3. Loosen the light assembly retaining screws with a cross-tip screwdriver. 4. Remove the rear combination lamp assembly from the body of the vehicle. 5. Disconnect the rear combination lamp connector. 6. Remove the socket from the assembly ...

Kia Niro 2017 (DE HEV) Service Manual: Crankshaft Position Sensor (CKPS) Troubleshooting
Signal Waveform This example shows a typical Crankshaft Position Sensor (CKPS) and Camshaft Position Sensor (CMPS) waveforms at idle. The PCM controls the injection and ignition timing by using these signals. Generally, the CKPS signal is used to detect the piston position whe ...

© 2016-2019 www.kniro.net