Kia Niro: Crash Pad / Crash Pad Lower Panel Repair procedures

Kia Niro 2017 (DE HEV) Service Manual / Body (Interior and Exterior) / Crash Pad / Crash Pad Lower Panel Repair procedures

Replacement

Put on gloves to protect your hands.

•	Use a plastic panel removal tool to remove interior trim pieces without marring the surface.

•	Be careful not to bend or scratch the trim and panels.

1.	Remove the crash pad side cover [LH] (A) by using a remover.

2.	Remove the crash pad lower panel (A) after loosening the screw.

3.	Disconnect the fuel filler door switch connector (A).

Install in the reverse order of removal.

•	Make sure the connector is connected properly.

•	Replace any damaged clips.

Crash Pad Lower Panel Components and components location

Component Location 1. Crash pad lower panel ...

Glove Box Housing Components and components location

Component Location 1. Glove box housing complete ...

Other information:

Kia Niro (DE HEV) Owners Manual: Temperature control
The temperature will increase to the maximum by turning the knob to the extreme right. The temperature will decrease to the minimum by turning the knob to the extreme left. When turning the knob, the temperature will increase or decrease by 0.5°C/1°F. When set to the lowest temperature s ...

Kia Niro 2017 (DE HEV) Service Manual: Manifold Absolute Pressure Sensor (MAPS) Repair procedures
Inspection 1. Connect the KDS/GDS on the Data Link Connector (DLC). 2. Measure the output voltage of the MAPS during idle with IG ON. Pressure [kPa (kgf/cm², psi)] Output Voltage (V) [Vref = 5V] ...