Kia Niro: Engine oil / Checking the engine oil level

Kia Niro (DE HEV) Owners Manual / Maintenance / Engine oil / Checking the engine oil level

■ Gasoline Engine (Kappa 1.6L-GDI)

1. Be sure the vehicle is on level ground.

2. Start the engine and allow it to reach normal operating temperature.

3. Turn the engine off and wait for a few minutes (about 5 minutes) for the oil to return to the oil pan.

4. Pull the dipstick out, wipe it clean, and re-insert it fully.

WARNING - Radiator hose

Be very careful not to touch the radiator hose when checking or adding the engine oil as it may be hot enough to burn you.

5. Pull the dipstick out again and check the level. The level should be between F (Full) and L (Low).

CAUTION

■ Gasoline Engine (Kappa 1.6L-GDI)

If it is near or at L (Low), add enough oil to bring the level to F (Full). Do not overfill.

Use a funnel to help prevent oil from being spilled on engine components.

Use only the specified engine oil. (Refer to “Recommended lubricants and capacities” in chapter 9.)

Engine oil
...

Changing the engine oil and filter
We recommend that the engine oil and filter be replaced by an authorized Kia dealer. WARNING Used engine oil may cause skin irritation or cancer if left in contact with the skin for prolonged pe ...

Other information:

Kia Niro (DE HEV) Owners Manual: Vehicle weight
This section will guide you in the proper loading of your vehicle and/or trailer, to keep your loaded vehicle weight within its design rating capability, with or without a trailer. Properly loading your vehicle will provide maximum return of the vehicle design performance. Before loading your ...

Kia Niro 2017 (DE HEV) Service Manual: Injector Troubleshooting
Signal Waveform The three waveforms below are taken from the #1 and #4 injectors. The top waveform is from the high side (feed side) of the #1 and #4 injectors, while the middle waveform is from the low side (ground side) of the #1 injector and the bottom waveform is from the low ...

© 2016-2018 www.kniro.net