Toyota Corolla: Wi-Fi® Hotspot / Changing the Wi-Fi® settings

1 Press the “MENU” button.

Toyota Corolla. Changing the Wi-Fi® settings

2 Select “Setup”.

3 Select “Wi-Fi*”.

*: Wi-Fi® is a registered trademark of Wi-Fi Alliance®.

4 Select the desired item to be set.

Toyota Corolla. Changing the Wi-Fi® settings

A - Select to enable/disable the Wi-Fi® Hotspot function.

B - Select to check/change the access point password.

C - Select to display hints for connecting to the vehicle via Wi-Fi®.

D - Select to make the access point searchable/unsearchable.

E - Select to check/change the security protocol of the access point (for authentication and encryption).

F - Select to change the access point name (SSID).

G - Select to change the Wi-Fi® connection channel (within the 2.4GHz frequency band).

If any settings have been changed, it will be necessary to reset the Wi-Fi® system to complete the changes. To reset the Wi-Fi® system, select “Yes” on the pop-up displayed after changing the settings.

Enabling/disabling the Wi-Fi® Hotspot function

When the Wi-Fi® Hotspot function is enabled, the system checks for a valid Hotspot service subscription.

If a hotspot service subscription has not been started, connect your device to the in-vehicle access point to start your subscription. A trial subscription may be available.

Checking/changing the password

1 Select “Password”.

2 Check that the following screen is displayed.

Toyota Corolla. Changing the Wi-Fi® settings

A - Displays the password

B - Select to display/hide the entered password.

C - Select to change the password.

Changing the password

1 Select “Change Password”.

2 Enter the desired password and select “OK”.

When setting/changing a password, observe the following guidelines to help prevent the password from being cracked by a third party:

Changing the security protocol

1 Select “Security”.

2 Select the desired security protocol.

Changing the access point name (SSID)

1 Select “Access Point Name”.

2 Enter the desired access point name (SSID) and select “OK”.

Selecting a Wi-Fi® connection channel

1 Select “Channel”.

2 Check that the following screen is displayed.

Toyota Corolla. Changing the Wi-Fi® settings

A - Select to change the channel selection to automatic/ manual.

B - When “Manual” is selected, select to change the channel.

Changing the channel

1 Set “Select Channel” to “Manual”.

2 Select “Channel Number”.

3 Enter the desired channel number and select “OK”.

Channels 1 through 11 can be selected.

Wi-Fi® Hotspot
By connecting a device to the vehicle via Wi-Fi®, it can access the internet through the DCM. To use this function, a Wi-Fi® Hotspot service subscription from Verizon Wireless is required. Cont ...

Wi-Fi® function operating hints
■Wi-Fi® function operating hints If a connected device is taken out of the Wi-Fi® connection area, the connection will be severed. If the vehicle is driven out of the cellular communication c ...

Other information:

Kia Niro (DE HEV) Owners Manual: Head lamp low beam (LHD)
1. Turn the low beam on without driver aboard. 2. The cut-off line should be projected in the cut-off line shown in the picture. 3. When aiming the low beam, vertical aiming should be adjusted after adjusting the horizontal aiming. 4. If head lamp leveling device is equipped, adjust the head la ...

Kia Niro 2017 (DE HEV) Service Manual: Rear Seat Belt Retractor Repair procedures
Replacement    When installing the belt, be careful not to damage the retractor. 1. Remove the rear pillar trim. (Refer to Interior Trim - "Rear Pillar Trim") 2. ...

© 2016-2022 www.kniro.net