Kia Niro: AHB(Active Hydraulic Boost) System / Brake Line Components and components location

Components

Pressure Source Unit Repair procedures
Removal 1. Turn ignition switch OFF and disconnect the negative (-) battery terminal. 2. Remove the air cleaner assembly. (Refer to Engine ...

Brake Line Repair procedures
Removal 1. Disconnect the brake fluid level switch connector, and remove the reservoir cap. 2. Remove the brake fluid from the master cylinder ...

Other information:

Kia Niro 2017 (DE HEV) Service Manual: Blind Spot Detection Radar Calibration Description and operation
Description To correctly sense vehicles on the neighboring lanes using the radar, the direction of the sensor and the direction of the vehicle must be aligned. This is the BSD unit alignment. If this alignment is not performed as in illustration below, it may cause degradation of ...

Kia Niro (DE HEV) Owners Manual: Lane changing
A vehicle which moves into your lane from an adjacent lane cannot be recognized by the sensor until it is in the sensor's detection range. • The sensor may not detect immediately when a vehicle cuts in suddenly. Always pay attention to the traffic, road and driving conditions. ...

© 2016-2020 www.kniro.net