Inspection |
1. |
Operate the heater controls at IGN2 to ensure that the motor is running.
|
2. |
If the blower motor does not operate well, substitute with a known-good blower motor and check for proper operation. |
3. |
Replace the blower motor if it is proved that there is a problem with it. |
Replacement |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the crash pad under cover (A) by pushing the locking pin.
|
3. |
Disconnect the blower motor connector (A) and then remove the blower motor (B) after loosening the screws.
|
4. |
Install in the reverse order of removal. |
Kia Niro (DE HEV) Owners Manual: Warning message and warning light
When the sensor cover or the sensor lens is smudged with the foreign substances,
such as snow or rain, the AEB operation may temporarily stop. In this case, the
warning message appears to warn the driver.
This is not a malfunction with the AEB. To operate the AEB again, remove the
foreign s ...
Kia Niro 2017 (DE HEV) Service Manual: Description and operation
Warning Lamp Activation
Warning Lamp Behavior after Ignition
On
As soon as the operating voltage is applied to the SRSCM ignition input, the
SRSCM activates the warning lamp for a LED lamp check.
The lamp shall turn on for 6 seconds during the initialization phase ...