Kia Niro: AVN System / AVN Remote Controller Repair procedures

Kia Niro 2017 (DE HEV) Service Manual / Body Electrical System / AVN System / AVN Remote Controller Repair procedures

Removal
1.

Disconnect the negative (-) battery terminal.

2.

Remove the steering wheel assembly.

(Refer to Steering System - "Steering Wheel")

3.

Remove the steering back cover (A) after loosening the mounting screws.

4.

Remove the wiring connector (A) from the steering back cover.

5.

Disconnect the steering wheel remote control connector (A).

[LH]

[RH]

6.

Remove the steering wheel remote control assembly (A) after loosening the mounting screws.

7.

Remove the steering wheel remote control (A) after loosening the mounting screws.

[LH]

[RH]

Installation
1.

Install the steering wheel remote control.

2.

Install the steering wheel remote control assembly.

3.

Connect the steering wheel remote control connector.

4.

Install the steering back cover.

5.

Install the steering wheel and driver airbag module.

6.

Connect the negative (-) battery terminal.

Inspection
1.

Check for resistance between terminals in each switch position (LH).

[LH : Audio + Hands free + Voice]

Switch
Connector
terminal
Resistance
(±3%)
SEEK Up
1-6
430 ?
SEEK Down
1.11 k?
MODE
2.11 k?
MUTE
3.11 k?
Volume (+)
4.61 k?
Volume (-)
6.81 k?
Voice
10.71 k?
END
18.91 k?
SEND
40.91 k?

2.

Check for resistance between terminals in each switch position (RH).

[RH : Cruise + Trip]

Switch
Connector
terminal
Resistance
(±5%)
Cancel
2-6
390 ?
SET -
610 ?
RES +
910 ?
Cruise ON/OFF
1.38 k?
Cruise & Speed Limit ON/OFF
2.13 k?
SCC (Following distance control)
3.63 k?
Group
1-6
390 ?
Trip Up
610 ?
Trip Down
910 ?
ENTER
1.38 k?

AVN Remote Controller Schematic diagrams
Circuit Diagram [Audio + Bluetooth] [Audio + Bluetooth + Voice] [Trip] [Trip + Cruise] [Trip + Cruise + SCC] ...

Multimedia Jack Schematic diagrams
Circuit Diagram ...

Other information:

Kia Niro (DE HEV) Owners Manual: Checking the engine oil level
■ Gasoline Engine (Kappa 1.6L-GDI) 1. Be sure the vehicle is on level ground. 2. Start the engine and allow it to reach normal operating temperature. 3. Turn the engine off and wait for a few minutes (about 5 minutes) for the oil to return to the oil pan. 4. Pull the dipstick out, wipe it ...

Kia Niro (DE HEV) Owners Manual: START/RUN
Not illuminated To start the engine, depress the brake pedal and press the engine start/stop button with the shift lever in the P (Park) or the N (Neutral) position. For your safety, start the engine with the shift lever in the P (Park) position. ✽ NOTICE If you press the engine start/sto ...

© 2016-2019 www.kniro.net