Peugeot 2008: Lighting and visibility / Automatic illumination of headlamps

Peugeot 2008 2019-2021 Owner's Manual / Lighting and visibility / Automatic illumination of headlamps

When the ring is at the  "AUTO" position and a low level of ambient light is detected by the rain/sunshine sensor, the number plate lamps,   sidelamps and dipped beam headlamps are switched on automatically, without any action on the part of the driver. They can also come on if rain is detected, at the same time as automatic operation of the windscreen wipers.

As soon as the brightness returns to a sufficient level or after the windscreen wipers are switched off, the lamps are switched off automatically.

Malfunction

Peugeot 2008. Automatic illumination of headlamps In the event of a malfunction of the rain/sunshine sensor, the vehicle’s lighting comes on and this warning lamp is displayed in the instrument panel, accompanied by an audible signal and/or the display of a message.

Contact a PEUGEOT dealer or a qualified workshop.

Peugeot 2008. Automatic illumination of headlamps Do not cover the rain/sunshine sensor located at the top centre of the windscreen behind the interior rear view mirror; the associated functions would no longer be controlled.

Peugeot 2008. Automatic illumination of headlamps In fog or snow, the rain/sunshine sensor may detect sufficient light. In this case, the lighting will not come on automatically.

Headlamp beam height adjustment
Manually adjusting the halogen or LED technology headlamps To avoid dazzling other road users, the height of these headlamp beams should be adjusted according to the load in the vehicle. 0 (Initial ...

Guide-me-home and welcome lighting
Guide-me-home lighting Automatic With the ring in the "AUTO" position, when the light is poor, the dipped beam headlamps come on automatically when the ignition is switched off. You can activate/dea ...

Other information:

Kia Niro 2017 (DE HEV) Service Manual: Description and operation
Description The Hybrid Power Control Unit (HPCU) uses various semiconductors that are supplied with high voltage, hence generating more heat than engine combustion devices. Overheating can decrease the efficiency of control devices, restrict proper operation and melt semiconductor ...

Kia Niro (DE HEV) Owners Manual: To turn off the speed limit control, do one of the following
Press the CRUISE & SPEED LIMIT MODE switch. Turn the ignition off. If you press the cancel O switch once, the set speed limit will cancel, but it will not turn the system off. If you wish to reset the speed limit, move the lever up (to RES+) or down (to SET-) to the desired speed. ...

© 2016-2021 www.kniro.net