Kia Niro: Windshield defrosting and defogging / Auto defogging system

Auto defogging reduces the possibility of fogging up the inside of the windshield by automatically sensing the moisture of inside the windshield.

This indicator illuminates when the auto defogging system senses the moisture of inside the windshield and operates.

If more moisture is in the vehicle, higher steps operate as follow.

(For European region)

Step 1 : Blowing air flow toward the windshield

Step 2 : Increasing air flow toward the windshield

Step 3 : Operating the air conditioning.

Step 4 : Outside air position

(For except european region)

Step 1 : Outside air position

Step 2 : Operating the air conditioning

Step 3 : Blowing air flow toward the windshield

Step 4 : Increasing air flow toward the windshield

To cancel or reset the Auto Defogging System

Press the front windshield defroster button for 3 seconds when the ignition switch is in the ON position.

When the ADS system is canceled, Indicator on the button will blink 3 times per 0.5 sec.

When the ADS system is reset, Indicator on the button will blink 6 times per 0.25 sec.

Automatic climate control system
1. Turn the ignition switch to the ON position. 2. Press the defroster button (). 3. While pressing the air conditioning button (A/C), press the air intake control button at least 5 times within ...

Clean air
When the ignition switch is in the ON position, the clean air function turns on automatically. Also, the clean air function turns off automatically, when the ignition switch turns to the OFF po ...

Other information:

Kia Niro 2017 (DE HEV) Service Manual: Crankshaft Repair procedures
Disassembly    • Be sure to read and follow the “General Safety Information and Caution” before doing any work related with the high voltage system. Failure to follow the safety i ...

Kia Niro (DE HEV) Owners Manual: To set speed limit
1. Press the CRUISE & SPEED LIMIT MODE ( ) button twice on the steering wheel, to turn the system on. The speed limit indicator light will illuminate. 2. Move the lever down (to SET-). 3. Move the lever up (to RES+) or down (to SET-), and release it at the desired speed. Move the ...

© 2016-2024 www.kniro.net