Kia Niro: Heater / Auto Defogging Actuator Description and operation
| Description |
Installed on the windshield glass, the auto defogging sensor detects humidity to blow out wind for defogging to improve visibility and driver comfort. The air conditioner control module receives a signal from the sensor and restrains moisture and eliminates defog by the intake actuator, A/C, auto defogging actuator, blower motor rpm and mode actuator.
Auto Defogging Actuator Components and components location
Components Location
1. Auto Defogging Actuator
...
Auto Defogging Actuator Repair procedures
Inspection
1.
Switch "OFF" the ignition.
2.
Disconnect the auto defogging sensor connector.
3.
Connect the pow ...
Other information:
Kia Niro (DE HEV) Owners Manual: Jump starting procedure
1.Make sure the booster battery is 12-volt and that its negative terminal is
grounded.
2.If the booster battery is in another vehicle, do not allow the vehicles come
in contact.
3.Turn off all unnecessary electrical loads.
4.Connect the jumper cables in the exact sequence shown in the illustr ...
Kia Niro 2017 (DE HEV) Service Manual: TPMS Receiver Repair procedures
Removal
1.
Disconnect the battery negative cable.
2.
Remove the glove box.
(Refer to Body - "Glove Box Housing")
3.
Disconnect the blower motor connector (A).
4.
Disconnect ...