Kia Niro: Audio / Audio Unit Components and components location

Kia Niro 2017 (DE HEV) Service Manual / Body Electrical System / Audio / Audio Unit Components and components location

Components
[RADIO/CD/MP3]

Connector Pin Information

No.
Connector A
Connector B
1
Rear left speaker (+)
-
2
Rear left speaker (-)
MIC (+)
3
USB Ground
-
4
USB D (+)
-
5
USB D (-)
Remote antenna
6
USB Power
Illumination (+)
7
Camera VIN / Camera VIN (Y)
Multmedia-CAN (High)
8
-
-
9
-
-
10
AUX Right input
Battery (+)
11
AUX Detect
Battery (+)
12
Steering wheel remote controller
Ground
13
Front left speaker (+)
Ground
14
Front left speaker (-)
MIC Ground
15
Front right speaker (-)
MIC (-)
16
Front right speaker (+)
-
17
-
-
18
-
Vehicle speed
19
-?
Illumination (-)
20
Camera Power
Multmedia-CAN (Low)
21
Camera VIN shield / Camera VIN (Y) shield (Ground)
-
22
-
ACC
23
-
-
24
AUX Left input
-
25
AUX Ground
-
26
Steering wheel remote controller (Ground)
-
27
Rear right speaker (-)
-
28
Rear right speaker (+)
-
29
-
-
30
-
-
31
-
-
32
Camera Ground
IGN1
33
Camera VIN shield / Camera VIN (Y) shield
-
34
-
-
35
-
-
36
Camera Detect

37
-
38
-

Components and components location
Component Location 1. Audio unit 2. Tweeter speaker 3. Front door speaker 4. Rear door speaker 5. Antenna feeder cable 6. Roof antenna (AM/FM) ...

Audio Unit Repair procedures
Removal    • When removing with a flat-tip screwdriver or remover, wrap protective tape a ...

Other information:

Kia Niro (DE HEV) Owners Manual: Changing a tire with TPMS
If you have a flat tire, the low Tire Pressure and Position telltales will come on. We recommend that the system be checked by an authorized Kia dealer. CAUTION We recommend that you use the sealant approved by Kia. The sealant on the tire pressure sensor and wheel shall be eleminated when yo ...

Kia Niro 2017 (DE HEV) Service Manual: Overhead Console Lamp Repair procedures
Inspection 1. Remove the overhead console lamp assembly then check for continuity between terminals. If the continuity is not as specified, replace the map lamp switch. Removal 1. Disconnect the negative (-) ba ...

© 2016-2020 www.kniro.net